Enhanced Interior Gateway Routing Protocol (Eigrp) Zero-Hero

Published 3/2023MP4 | Video: h264, 1280x720 | Audio: AAC, 44.1 KHzLanguage: English | Size: 11.17 GB | Duration: 24h 39m

Pv4 , Pv6 concept & configuration ( IOS , NX-OS , ASA ) & troubleshooting and design

P Fundamentals and Basic Configuration

P Neighborship Process

P Path Metric Calculation

P Convergence

P Load-Balancing

P Summarization

P Stub Router and Site

P WAN Considerations

P Filtering with ACL and IP Prefix-List

P Filtering with Route-Map and Gateway

P Offset List

Troubleshooting P for IPv4

P for IPv4 Trouble Tickets

P for IPv6 (Pv6)

Pv6 and Named P Trouble Tickets

P OTP - Full Mesh

P OTP - Route Reflector

P OTP - Redundant Remote Routers

IPv6 P OTP - Full Mesh

IPv6 P OTP - Route Reflector

P Neighborship in NX-OS

P Authentication in NX-OS

P Passive-Interface in NX-OS

P Summarization in NX-OS

P Stub in NX-OS

P Configuration with CLI in ASA

P Configuration with ASDM in ASA

P Design - P with Multiple AS , Multilayer Architectures

P Design - P Hub-and-Spoke Design

P Design - P Fast Convergence and GR-NSF

You need to know about routing fundamentals . You can implement all of scenarios in GNS-3 or EVE-NG.

Enhanced Interior Gateway Routing Protocol (P) is an advanced distance-vector routing protocol that is used on a computer network for automating routing decisions and configuration. The protocol was designed by Cisco Systems as a proprietary protocol, available only on Cisco routers. In 2013 Cisco decided to allow other vendors freely implement limited version of P with some of its associated features such as High Availability (HA), while withholding other P features such as P stub, needed for DMVPN and large-scale campus deployment, exclusively for themselves. Information needed for implementation was published with informational status as RFC 7868 in 2016, which did not make it into an Internet Standards Track specification and allowed Cisco to retain control of the P protocol.P is used on a router to share routes with other routers within the same autonomous system. Unlike other well known routing protocols, such as RIP, P only sends incremental updates, reducing the workload on the router and the amount of data that needs to be transmitted.P replaced the Interior Gateway Routing Protocol (IGRP) in 1993. One of the major reasons for this was the change to classless IPv4 addresses in the Internet Protocol, which IGRP could not support.

Section 1: Enhanced Interior Gateway Routing Protocol (P) in IOS

Lecture 1 P Fundamentals and Basic Configuration

Lecture 2 P Neighborship Process

Lecture 3 P Path Metric Calculation

Lecture 4 P Convergence

Lecture 5 P Load-Balancing

Lecture 6 P Summarization

Lecture 7 P Stub Router and Site

Lecture 8 P WAN Considerations

Lecture 9 P Filtering with ACL and IP Prefix-List

Lecture 10 P Filtering with Route-Map and Gateway

Lecture 11 P Offset List