Each tap has selectable feedback, stereo image and position, delay time, multimode filter, modulation, drive/tape saturation, and reverb. Moreover, the feedback and drive can be placed at the beginning or end of the signal chain for even more sound design options!

The modulation section offers both an LFO and envelope follower, and the tape saturation algorithm is taken from our renowned mastering processors. And of course this can all be done at any bit depth and sample rate up to 24-bit/384 kHz, and be fully automated via MIDI and your host software!

Up to 8 seconds of delay time per channel

Continuous control over the delay time in milliseconds and/or chosen note quantization

Three operation modes: MULTIDELAY, in which each tap has its own feedback buffer; MULTITAP, in which the Master Feedback operates on one (user selectable) tap; and MULTIFB, where turning off a tap leaves its feedback buffer signal active

Each tap includes independent adjustment of gain, stereo field width and balance, 
delay time, filtering, modulation, saturation simulation, and reverberation

Each tap can choose between multiple biquadratic filter types, including Low Pass, Band Pass, High Pass, Peak, and four Shelf filters

Modulation section (LFO and envelope follower) offer adjustable modulation depth of 
±3 octaves, and can also be used to control filter cutoff

Tape saturation simulation with adjustable gain, based on the algorithm used in our mastering processors

Filtering module in feedback includes LP/BP/HP filter (either State Variable Filter or Biquad) with adjustable cutoff and resonance

Vintage reverberation module for faithful simulation of spring and plate reverbs

Support for sample rates up to 384 kHz

Host automation of all processing parameters

A witch says,
* No iLok Driver installation is required to run.
* Our release loads faster and uses less memory than legit version.

home page: https://www.pspaudioware.com/products/psp-608md

DOWNLOAD HERE